⚡ ELEC-SIM
Electrical Wiring & Troubleshooting Simulator
SELECTED COMPONENT
Click a component to inspect it.
Drag from the palette to add components.
Use WIRE mode to connect terminals.
Drag from the palette to add components.
Use WIRE mode to connect terminals.
SYSTEM STATUS
No components placed yet.
EVENT LOG
00:00Simulator ready · Drag components to start
HINT
Getting Started
1. Drag components from the left panel onto the canvas.
2. Switch to WIRE mode to connect terminals.
3. Click terminals to start/end a wire.
4. Use CHECK WIRING to validate your circuit.
2. Switch to WIRE mode to connect terminals.
3. Click terminals to start/end a wire.
4. Use CHECK WIRING to validate your circuit.
How to Use the Simulator
Adding Components
Drag any component from the left panel onto the canvas. It appears where you drop it.
Wiring
Click the WIRE button (or press W). Then click a terminal (colored circle) to start a wire, and click another terminal to complete the connection. Select a wire color before connecting.
Interacting
In SELECT mode, click components to inspect them. Use the buttons inside each component to START, STOP, TRIP, or RESET. Drag components to reposition them.
Fault Injection
Use the bottom bar to inject faults like open circuits, blown fuses, and overloads into the active circuit. Watch the event log to trace the fault.
Scenarios
Load a pre-built scenario to practice a specific wiring task. Follow the step-by-step instructions in the overlay panel.
On phone/tablet
Tap ☰ to open the Parts list, tap ℹ to open Details. Tap outside a panel to close it. Pinch-free — just tap a component to select it, then use its buttons to operate it.
Drag any component from the left panel onto the canvas. It appears where you drop it.
Wiring
Click the WIRE button (or press W). Then click a terminal (colored circle) to start a wire, and click another terminal to complete the connection. Select a wire color before connecting.
Interacting
In SELECT mode, click components to inspect them. Use the buttons inside each component to START, STOP, TRIP, or RESET. Drag components to reposition them.
Fault Injection
Use the bottom bar to inject faults like open circuits, blown fuses, and overloads into the active circuit. Watch the event log to trace the fault.
Scenarios
Load a pre-built scenario to practice a specific wiring task. Follow the step-by-step instructions in the overlay panel.
On phone/tablet
Tap ☰ to open the Parts list, tap ℹ to open Details. Tap outside a panel to close it. Pinch-free — just tap a component to select it, then use its buttons to operate it.